RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: Edgar Perez
Showing results 1 to 25 of 53
Search took 0.01 seconds.
Forum: RC Jets
10-15-2020, 03:15 AM
Replies: 568
Views: 115,820
Posted By Edgar Perez

ffffff I did my initial balancing easily enough...

ffffff
I did my initial balancing easily enough with a giant plane balancer like the photo. ...
Forum: RC Jets
09-14-2020, 06:48 AM
Replies: 568
Views: 115,820
Posted By Edgar Perez

Short update on mine: Went to start the turbines...

Short update on mine: Went to start the turbines (JC Cheetah) and realized that the 4mm main fuel line was putting too much resistance and could not achieve full power. My setup in the fuselage is...
Forum: RC Jets
09-06-2020, 03:42 AM
Replies: 568
Views: 115,820
Posted By Edgar Perez

Nice, but I will be careful if charging LIPO...

Nice, but I will be careful if charging LIPO batteries inside the plane.
Forum: RC Jets
05-25-2020, 03:42 PM
Replies: 568
Views: 115,820
Posted By Edgar Perez

The replacement fan center section as received...

The replacement fan center section as received and found no issues with using the original bearings. They sure are expensive but look good.

https://youtu.be/AiJIpCz_2UQ
Forum: RC Jets
05-25-2020, 03:40 PM
Replies: 568
Views: 115,820
Posted By Edgar Perez

Progress on mine... Now on hold pending to...

Progress on mine... Now on hold pending to receive my firmware updated Powerbox Royal

https://youtu.be/86tQd_Fa84E
Forum: RC Jets
05-14-2020, 05:00 PM
Replies: 568
Views: 115,820
Posted By Edgar Perez

I actually agree with you. It was done as...

I actually agree with you. It was done as carefully as possible.
The controller do come with the connections to install a manual switch for operation, so i intent to set that up.
Forum: RC Jets
05-14-2020, 03:29 AM
Replies: 568
Views: 115,820
Posted By Edgar Perez

Yes, 2S worked for testing (connect direct to...

Yes, 2S worked for testing (connect direct to motor).. My controller came setup for 3S for normal use.
Forum: RC Jets
05-13-2020, 03:30 PM
Replies: 568
Views: 115,820
Posted By Edgar Perez

Mine is electric and i can just connect a battery...

Mine is electric and i can just connect a battery directly to the motor, disconnecting it as soon as it reaches the position. The polarity determines direction.
Forum: RC Jets
05-11-2020, 08:47 AM
Replies: 568
Views: 115,820
Posted By Edgar Perez

thanks for the panel lines info... looks good

thanks for the panel lines info... looks good
Forum: RC Jets
05-10-2020, 02:02 PM
Replies: 568
Views: 115,820
Posted By Edgar Perez

That look interesting.... How does it works?

That look interesting.... How does it works?
Forum: RC Jets
05-09-2020, 02:37 PM
Replies: 568
Views: 115,820
Posted By Edgar Perez

I got my fans too, but have no tried yet to...

I got my fans too, but have no tried yet to exchange it with the old one.
Let me know what Bogo says.
Thanks
Forum: RC Jets
05-08-2020, 11:09 AM
Replies: 568
Views: 115,820
Posted By Edgar Perez

First let me re-state that I don't have the...

First let me re-state that I don't have the ability to do this. My friend is doing the build and painting...
I didn't want to really do a lot of weathering, so I asked him to look at other methods...
Forum: RC Jets
05-07-2020, 11:02 AM
Replies: 568
Views: 115,820
Posted By Edgar Perez

Some detailing to enhance the panel lines... ...

Some detailing to enhance the panel lines...

https://youtu.be/3EHK1gDhOEk
Forum: RC Jets
05-03-2020, 03:47 PM
Replies: 568
Views: 115,820
Posted By Edgar Perez

Thanks. Nothing on the fans yet. I will...

Thanks.
Nothing on the fans yet. I will probably contact Bogo this eek to check if he sent them.
Forum: RC Jets
05-02-2020, 01:58 PM
Replies: 568
Views: 115,820
Posted By Edgar Perez

Good progress on mine. Some install images.:D ...

Good progress on mine. Some install images.:D
https://cimg1.ibsrv.net/gimg/www.rcuniverse.com-vbulletin/1200x1600/cf9c0de1_4e0e_4a17_b3d6_e6b3f0f06b20_66c527da6c7ac9a553e3081fbe53bce93302ea75.jpg...
Forum: RC Jets
04-20-2020, 07:07 AM
Replies: 568
Views: 115,820
Posted By Edgar Perez

Bogo from Mibo responded immediately to my...

Bogo from Mibo responded immediately to my request for replacement. Initial thinking is that the filament was bad. They will send me the center section. Really happy with the response. Hopefully they...
Forum: RC Jets
04-18-2020, 06:24 PM
Replies: 568
Views: 115,820
Posted By Edgar Perez

Broken Fans

So today found out that that both my fans are broken :mad:

Never used or mishandled. I don't think they came that way, so I guess that the 3d printed plastic had internal stresses that gave up....
Forum: RC Jets
04-17-2020, 06:15 PM
Replies: 568
Views: 115,820
Posted By Edgar Perez

Yes, one challenging part is the cut to separate...

Yes, one challenging part is the cut to separate the front canopy frame of the rear one. This is where the canopy open, so going oversize there don't help because it reduces it on the other side...
Forum: RC Jets
04-17-2020, 04:01 PM
Replies: 568
Views: 115,820
Posted By Edgar Perez

Getting to the point where the plastic canopy...

Getting to the point where the plastic canopy need to be cut to glue them to the canopy frames.
There are no marks in the plastics canopy to indicate where it needs to be cut, so I guess need to...
Forum: RC Jets
04-16-2020, 09:38 AM
Replies: 568
Views: 115,820
Posted By Edgar Perez

Anyone uses a wing bag to transport them? The...

Anyone uses a wing bag to transport them?
The wingtips and bomb stabilizers supports in the pylons look quite fragile...
Forum: RC Jets
04-16-2020, 09:36 AM
Replies: 568
Views: 115,820
Posted By Edgar Perez

Dont know about the pieces, will try to find out...

Dont know about the pieces, will try to find out with my builder
Forum: RC Jets
04-16-2020, 03:58 AM
Replies: 568
Views: 115,820
Posted By Edgar Perez

Too clean! Needs some weathering, but that comes...

Too clean! Needs some weathering, but that comes after...
Forum: RC Jets
04-15-2020, 08:04 PM
Replies: 568
Views: 115,820
Posted By Edgar Perez

https://cimg7.ibsrv.net/gimg/www.rcuniverse.com-vb...

https://cimg7.ibsrv.net/gimg/www.rcuniverse.com-vbulletin/1200x1600/b85c7a51_ad62_40f2_a078_3197b3921f74_86e55872ff90263cdbf0949c6c18c5db09652de4.jpg...
Forum: RC Jets
04-15-2020, 08:02 PM
Replies: 568
Views: 115,820
Posted By Edgar Perez

Both planes look great!

Both planes look great!
Forum: RC Jets
04-14-2020, 07:00 PM
Replies: 568
Views: 115,820
Posted By Edgar Perez

Just went thru the flap servo arm issue myself....

Just went thru the flap servo arm issue myself. It’s almost 2 inches.
...
Showing results 1 to 25 of 53
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.