RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: Craig B.
Showing results 1 to 6 of 6
Search took 0.03 seconds.
Forum: RC Jets
09-26-2019, 06:09 PM
Replies: 36
Views: 4,716
Posted By Craig B.

You should always be able to remove the thrust...

You should always be able to remove the thrust tube for servicing. Why can't you take it out? Normally they are just held in place with screws at the forward end.
Forum: RC Jets
09-26-2019, 02:14 AM
Replies: 36
Views: 4,716
Posted By Craig B.

Jim, check out post #6 on this thread..... ...

Jim, check out post #6 on this thread.....

http://www.rcuniverse.com/forum/rc-jets-120/5467269-my-skymaster-1-8-f16-fitout.html
Forum: RC Jets
09-26-2019, 01:55 AM
Replies: 36
Views: 4,716
Posted By Craig B.

Jim, do what Jonathan suggested above. In all of...

Jim, do what Jonathan suggested above. In all of my hornets I have lowered the nose gear to ensure a positive AOA on the ground; especially under load on takeoff. All you have to do then is go...
Forum: RC Jets
09-21-2019, 06:08 AM
Replies: 36
Views: 4,716
Posted By Craig B.

It will still leap off the ground with flaps if...

It will still leap off the ground with flaps if the fuel load makes it appreciably nose heavy. I had a bad experience with a yellow hornet for the exact same reason. Superhornet is worse than the C...
Forum: RC Jets
09-20-2019, 03:05 PM
Replies: 36
Views: 4,716
Posted By Craig B.

I wouldn’t have all of that fuel sitting way in...

I wouldn’t have all of that fuel sitting way in front of the c of g. The super hornet has a tendency to leap off the ground and this is exacerbated if you have a nose heavy model on takeoff.
Forum: RC Jets
09-17-2019, 07:32 AM
Replies: 36
Views: 4,716
Posted By Craig B.

I fly one of these powered by jet cat 160. Rear...

I fly one of these powered by jet cat 160. Rear tanks empty into front tank then to small INTAIRCO header. Only 6mm festo tubing. If you go smaller you are asking for cavitation problems, especially...
Showing results 1 to 6 of 6


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.