RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: Dave Wilshere
Showing results 1 to 12 of 12
Search took 0.01 seconds.
Forum: RC Jets
01-16-2023, 09:50 AM
Replies: 771
Views: 178,287
Posted By Dave Wilshere

My balance is safe with no fuel…tested that. It...

My balance is safe with no fuel…tested that. It was just an easy reference as we hook our fingers under the turbine opening side lips and lift. Hatch has to be off. Easy to eye ball down to the rear...
Forum: RC Jets
01-15-2023, 09:53 PM
Replies: 771
Views: 178,287
Posted By Dave Wilshere

Depends on the grass surface! Generally landing...

Depends on the grass surface! Generally landing on grass is more forgiving, but nose bounce will be down to how smooth the surface is.

Rebel balance is a factor of fuel on board. All the fuel is...
Forum: RC Jets
03-24-2022, 02:03 PM
Replies: 771
Views: 178,287
Posted By Dave Wilshere

PT-40 finishing resin is what I use

PT-40 finishing resin is what I use
Forum: RC Jets
02-02-2022, 09:47 PM
Replies: 771
Views: 178,287
Posted By Dave Wilshere

Tried that, ran the tube between the walls of the...

Tried that, ran the tube between the walls of the pipe with the same idea…poor smoke.
Forum: RC Jets
02-02-2022, 03:25 PM
Replies: 771
Views: 178,287
Posted By Dave Wilshere

Temperature is too low…so worse for excess oil...

Temperature is too low…so worse for excess oil left…but it does not get over the problem of the excess sucking back into the fuselage. That’s all aerodynamic.
When you are going quickly the un...
Forum: RC Jets
02-02-2022, 11:41 AM
Replies: 771
Views: 178,287
Posted By Dave Wilshere

The rear fuselage shape and ducting can suck from...

The rear fuselage shape and ducting can suck from the back. The only way to limit it is really control the oil flow and maximise atomisation from the nozzle
Forum: RC Jets
02-02-2022, 10:51 AM
Replies: 771
Views: 178,287
Posted By Dave Wilshere

In the case of a Rebel it’s not fussy on balance,...

In the case of a Rebel it’s not fussy on balance, but I would balance with 1/4 full smoke tank in this case. Just for a consistent feel through the flight…if it makes as much mess as most smoke...
Forum: RC Jets
02-01-2022, 09:55 PM
Replies: 771
Views: 178,287
Posted By Dave Wilshere

DW method! Wrap in insulation tape and CA down....

DW method! Wrap in insulation tape and CA down. Light, neat and repeatable. I’ve been doing it that way for 20 years.
Forum: RC Jets
01-24-2022, 10:04 PM
Replies: 771
Views: 178,287
Posted By Dave Wilshere

https://www.powerbox-systems.com/produkte/powerbox...

https://www.powerbox-systems.com/produkte/powerbox-systeme.html
Forum: RC Jets
01-24-2022, 10:48 AM
Replies: 771
Views: 178,287
Posted By Dave Wilshere

It’s all on PB’s web site. SRS serial receiver...

It’s all on PB’s web site. SRS serial receiver system. Once the model is booted up it will run on one Rx. The power system is probably the only true redundant one where there is duplication on...
Forum: RC Jets
10-26-2021, 04:37 AM
Replies: 771
Views: 178,287
Posted By Dave Wilshere

Wow, there is a site you don’t want a low/slow...

Wow, there is a site you don’t want a low/slow flame out! Great test flight, we’ll done.
Forum: RC Jets
02-12-2021, 11:33 AM
Replies: 771
Views: 178,287
Posted By Dave Wilshere

If the Flap linkage is set correct the servo load...

If the Flap linkage is set correct the servo load at full flap is almost zero.
Showing results 1 to 12 of 12


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.